USER MANUAL
Peplink Balance Series
http://www.peplink.com -92 / 261 - Copyright © 2015 Peplink
To enable drop-in mode, perform the following steps:
1. Check the Enable box under Drop-in Mode, located at Network>Interfaces>LAN.
(After checking the Enable box, most network settings for WAN1 will be hidden in
the web admin interface.)
2. Enter the IP address of the WAN1 router in the WAN Default Gateway field.
Ensure that the Peplink Balance’s IP subnet is the same as the firewall’s WAN port
and the router’s LAN port.
3. If there are hosts other than the router on the WAN segment of the Peplink
Balance, check the I have other host(s) on WAN segment box, enter the IP
address(es) of the host(s), and then click the down-arrow to add the hosts.
4. To avoid consuming an IP address, click to turn on the shared IP address
feature. Then check Share Drop-In IP and enter a Shared IP Address.
To Next Page
Loading...
