Timeout
This setting specifies the timeout in seconds for ping/DNS lookup requests. The
default timeout is 5 seconds.
Health Check
Interval
This setting specifies the time interval in seconds between ping or DNS lookup
requests. The default health check interval is 5 seconds.
Health Check
Retries
This setting specifies the number of consecutive ping/DNS lookup timeouts after
which the Peplink Balance will treat the corresponding WAN connection as down.
Default health retries is set to 3. Using the default Health Retries setting of 3, the
corresponding WAN connection will be treated as down after three consecutive
timeouts.
Recovery Retries
This setting specifies the number of consecutive successful ping/DNS lookup
responses that must be received before the Peplink Balance treats a previously
down WAN connection as up again. By default, Recover Retries is set to 3. Using
the default setting, a WAN connection that is treated as down will be considered
as up again upon receiving three consecutive successful ping/DNS lookup
responses.
Dynamic DNS Settings
Service Provider
This setting specifies the dynamic DNS service provider to be used for the
WAN. Supported providers are:
● changeip.com
● dyndns.org
● no-ip.org
● tzo.com
● DNS-O-Matic
Select Disabled to disable this feature.
To Next Page
Loading...
Need help?
General
