8 Configuring the LAN Interface(s)
8.1 Basic Settings
LAN interface settings are located at Network>LAN>Network Settings. Navigating to that
page will show the following dashboard:
This represents the LAN interfaces that are active on your router (including VLAN). A grey “X”
means that the VLAN is used in other settings and cannot be deleted. You can find which
settings are using the VLAN by hovering over the grey “X”.
Alternatively, a red “X” means that there are no settings using the VLAN. You can delete that
VLAN by clicking the red “X”
Clicking on any of the existing LAN interfaces (or creating a new one) will show the following :
IP Settings
IP Address
The IP address and subnet mask of the Pepwave router on the LAN.
To Next Page
Loading...
Need help?
General
