Navigating to AP>Settings on some Pepwave models displays a screen similar to the one
shown below:
This option sets the country whose regulations the Pepwave router follows.
Choose from the router's internal or optional external antennas, if so equipped.
Per FCC regulations, the country selection is not available on all models marketed in the US. All US
models are fixed to US channels only.
This option allows you to specify whether 802.11b and/or 802.11g client
association requests will be accepted. Available options are 802.11ng and
802.11na . By default, 802.11ng is selected.
This option allows you to select which 802.11 RF channel will be used.
Channel 1 (2.412 GHz) is selected by default.
Auto (20/40 MHz) and 20 MHz are available. The default setting is Auto
(20/40 MHz), which allows both widths to be used simultaneously.
This option is for specifying the transmission output power for the Wi-Fi AP.
There are 4 relative power levels available – Max , High , Mid , and Low . The
actual output power will be bound by the regulatory limits of the selected
country.
This option is for setting the transmit bit rate for sending a beacon. By default,
To Next Page
Loading...
Need help?
General
