2020-01
14
WCS* Read Head Position Encoding System
Data Cables and Mounting/Dismounting the Read Head
3.2 Mounting/Dismounting the Read Head Enclosure
If required, the factory default setting of the read head can be changed using the respective
DIP switches. The DIP switches are located inside the housing on the PCB of the read head. To
access the DIP switches, open the enclosure cover of the read head. Proceed as follows:
Mounting/Dismounting
1.
Disconnect the device from the power supply.
Figure 3.1 Opening the read head
2.
Open the read head by removing the four screws (4) on the bottom of the read head.
Warning!
Property damage caused by electrostatic discharge (ESD)
If the housing is opened, the electronics may be damaged by electrostatic dis-
charges.
• Use a wrist grounding strap or other ESD protective measures.
To Next Page
Loading...
