7.1.2 Firmware
The Firmware section lets you check the firmware version currently used by your
access point, as well as check for and install new firmware via online download. You
can also upgrade your firmware using a firmware file stored locally.
To check for new firmware, click the Check for Firmware button. If new firmware is
available, your access point will automatically download and install it.
To upgrade your access point using a firmware file on your network, click Choose File
to select the firmware file. Then click Manual Upgrade to initiate the firmware upgrade
process using the selected file.
Note that your access point can store two different firmware versions in two different
partitions. A firmware upgrade will always replace the inactive partition. If you want to
keep the inactive firmware, simply reboot your device with the inactive firmware and
then perform the firmware upgrade.
7.1.3 Time
The settings in this section govern the access point’s system time zone and allow you to
specify a custom timeserver.
Time region used by the system. All choices are based on UTC.
To choose a time server other than the default, enter the URL here. To restore the
default time server, click the Default button.
To Next Page
Loading...
Need help?
General
