Confirm
Authentication
Password
Re-enter the authentication password.
Select None or CBC-DES as the SNMPv3 privacy protocol. When CBC-DES is
selected, an entry field will appear for the password.
Select Read Only or Read and Write as the SNMPv3 access mode.
Use these controls to enable or disable SNMPv3 access.
7.1.6 Controller
In the Controller section, you can set up Peplink InControl or AP Controller remote
management.
Controller Management Settings
Check this box to enable remote management.
Select Auto, InControl, or AP Controller as your remote AP management method.
When Auto is selected, your access point will automatically choose the appropriate
mode.
To Next Page
Loading...
Need help?
General
