Click New SSID to create a new network profile, or click the existing network profile to
modify its settings.
Check this box to enable wireless SSID.
Available only on the AP One AC mini, this setting, shown below, allows you to
enable or disable either of the two on-board radios.
This setting specifies the AP SSID that Wi-Fi clients will see when scanning.
This setting specifies whether or not Wi-Fi clients can scan the SSID of this wireless
network. Broadcast SSID is enabled by default.
Select Auto to allow your access point to set the data rate automatically, or select
Fixed and choose a rate from the drop-down menu. Click the MCS Index link to
display a reference table containing MCS and matching HT20 and HT40 values.
This setting enables the filtering of multicast network traffic to the wireless SSID.
This setting specifies the transmit rate to be used for sending multicast network
traffic.
To allow your access point to convert multicast traffic to unicast traffic for associated
clients, select this option.
To set your access point as a DHCP server or relay, select Server or Relay.
Otherwise, select None.
If you use a distributed DHCP server/relay environment, you can enable this option to
provide additional information on the manner in which clients are physically
connected to the network.
To Next Page
Loading...
Need help?
General
