Check this box to forward traffic sent to the WAN IP address to the DMZ IP address.
Enter an IP address clients will use to connect to the DMZ.
To create a port forwarding rule, first click the Add Service button, located in the Port
Forwarding section.
Enter a name for the new port forwarding rule. Valid values for this setting consist of
alphanumeric and underscore “_” characters only.
The IP Protocol setting, along with the Port setting, specifies the protocol of the service
as TCP, UDP, ICMP, or IP. Traffic that is received by your access point via the specified
protocol at the specified port(s) is forwarded to the LAN hosts specified by the Servers
setting. Please see below for details on the Port and Servers settings.
Alternatively, the Protocol Selection Tool drop-down menu can be used to
automatically fill in the protocol and a single port number of common Internet services
(e.g., HTTP, HTTPS, etc.). After selecting an item from the Protocol Selection Tool
drop-down menu, the protocol and port number remain manually modifiable.
The Port setting specifies the port(s) that correspond to the service, and can be
configured to behave in one of the following manners:
Single Port, Port Range, Port Mapping
To Next Page
Loading...
Need help?
General
