Need help?Do you have a question about the peret FLUO and is the answer not in the manual?
General| Brand | peret |
|---|---|
| Model | FLUO |
| Category | Measuring Instruments |
| Language | English |
Procedure to reset the device, clear references, and check firmware version.
Guide to entering configuration mode and setting device parameters like reference averaging and display mode.
Procedure to save current configuration and exit the setup mode.
Steps for calibrating the device using zero and 100% reference samples.
How to set the zero reference on a non-fluorescent surface.
Procedure to measure a single solid reference for 100% calibration.
Measure multiple solid references to calculate an average for calibration.
How to measure samples in color mode and view XYZ color channels.
How to measure samples in intensity mode and interpret results.
Describes measurement results outside normal ranges (underflow uF, overflow oF).
Indicates 'ooo' when the UV LED does not switch on due to an open aperture.
Indicates '---' if the measurement was taken too quickly.
To Next Page