PERET GmbH/S.r.L www.peret.it info@peret.it
RESET the FLUO
Press the RESET button on the bottom side of the device to perform a
RESET. Resetting will delete all internally stored references. The Display will
show the device type for a few seconds.
in case of near UV LED only
in case of near and far UV LED
After a few seconds the display will change and show the actual firmware
version number
After initialization the device will show ‘0’. Now the device is ready for
measurements.
Press the RESET button and keep the right key depressed during reset
to perform a FACTORY RESET. The factory Reset will reset all settings and
configuration to its defaults.
Configure the device to your needs
The FLUO can be configured to your needs in a special configuration mode.
Press the right key for at least 5 seconds to enter configuration mode
The configuration mode is displayed by a ‘~’ in the left top corner of the LCD.
There are actually two settings that can be configured:
a) Average Solid Reference
b) Color Mode or Intensity Mode
To Next Page
Loading...