FLUO Manual v2.02 GB.docx
PERET GmbH/S.r.L www.peret.it info@peret.it
FLUO
The FLUO UV-Fluorescence measurement device is equipped with either with
two UV light sources, one in the near UV and one in the far UV or in case of
FLUO 365 only with the near UV light source. The dominant wave length of
the near UV illumination is 365nm while the dominant wave length of the far
UV illumination is 280nm. The FLUO can be equipped with 255nm replacing
the 280nm Illumination.
On the receiver side there are 3 bandwidths to measure the fluorescent effect
according to the sensitivity of human eyes, i.e. X (red sensitivity), Y (green
sensitivity), and Z (blue sensitivity).
The FLUO is supplied with a USB 2.0 cable to output data to a PC. As an
optional there is offered the FLUOcol Software which connects to the device.
To Next Page
Loading...