PERET GmbH/S.r.L www.peret.it info@peret.it
Safety Instructions
For safety reasons it is absolutely necessary to read through the user's guide
and all of the instructions it contains. If the safety recommendations and
instructions in this User Guide are not complied with, measurement errors or
data loss or physical injury or property damage may result.
• FLUO is not intrinsically safe. Therefore, the device cannot be used in
an environment with explosive vapors where there is a risk of spark
ignition or in an area with strong electromagnetic fields. It should be
protected against chemicals, corrosive vapors, strong mechanical
vibrations and impacts.
• Use the FLUO in ambient temperatures between 15°C(59°F) and 40°C
(104°F), and do not expose them to direct sun light.
• The FLUO should never be opened as there are no user-serviceable
parts. Doing so voids the guarantee. Contact your authorized dealer if
repairs are necessary.
• To prevent the operator from looking directly into the light source the
FLUO should be positioned onto a substrate while taking a
measurement. If not positioned onto a substrate there cannot be taken
any measurements as the UV illumination will not switch on at all.
• To avoid incorrect handling, the FLUO should only be used by trained
personnel
• Use original PERET spare parts and accessories only.
• Use the original packaging exclusively when transporting.
• The FLUO is equipped with UV LEDs. Do never look directly into the
optical System of the device during measurement.
Important: This manual describes the current version of the FLUO hardware
and software. Future enhancements or modifications are reserved.
To Next Page
Loading...