PERET GmbH/S.r.L www.peret.it info@peret.it
How to use the FLUO
During a measurement in case of FLUO 365 there will be calculated three
measurement values, one for X, one for Y, and one for Z. In case of FLUO
(near and far UV) there will be displayed additional X, Y, and Z values for the
far UV response (280nm or 255nm). The FLUO can be used in two modes:
the color mode will show XYZ for near and far UV, the intensity mode will
show only the intensity of the near or the far UV. The mode is selected in the
configuration (see below).
The LCD shows the actual measurement value. The active light source and
the receptor are displayed by a flashing LED on top of the FLUO device.
Example:
Example 1: green color channel (Y), near UV illumination, color mode
Example 2: green color channel (Y), far UV illumination, color mode
Example 3: near UV illumination, intensity mode
Example 4: far UV illumination, intensity mode
A little triangle symbol in the left top corner of the LCD tells the operator, that
far UV is active. In case of near UV illumination there will be no triangle
symbol in the left top corner of the LCD.
To Next Page
Loading...