PERET GmbH/S.r.L www.peret.it info@peret.it
Click the right key to switch between below settings a) and b)
a) Use an average solid reference
The FLUO can be configured to calculate the average of a sequence of up to
10 readings on your reference patch. The number of readings that need to be
measured to calculate the reference can be configured in the configuration
mode
click the up key on the device to increment the number of readings
click the down key to decrement the number of readings
b) Select color display or intensity display
The FLUO can be used in two different modes.
In Color mode there will be displayed automatically the dominant fluorescent
color after any 100% reference reading. By clicking the right key after a
measurement the next XYZ color channel will be displayed – following by the
XYZ color channels of the far or near UV readings.
The intensity mode will display only two values, one for near UV and one for
Far UV, expressing the light emission inside the visual spectrum.
toggle between the two modes by clicking the left key on your device.
Exit the configuration mode
To Next Page
Loading...