Perfect Flame 730-0522 - Page 17

17
WARNING
When lighting, keep your face and hands as far
away from the grill as possible.
CAUTION
When using a match to light the grill make sure to
use the attached lighting rod.
CAUTION
Remove the warming rack when using a match to
light the rotisserie burner.
To Light the Main Burner
1. Make sure all the knobs are in the “OFF” position, and then turn the Liquid Propane cylinder valve “ON”
by slowly turning counterclockwise.
2. Open the lid, push and turn the main burner knob slowly to “IGNITE/HI”, burner should light
immediately, adjust knob as desired after burner is lit.
3. If the burner does not light, turn the knob to “OFF” and repeat lighting procedure.
4. If the burners still do not light, turn the knob “OFF”, wait 5 minutes for any excess gas to dissipate and
repeat lighting procedure or follow the Match Lighting Instructions on page 17.
5. Check for proper burner flame characteristics. Each burner is adjusted prior to shipment; however,
variations in the local gas supply may make minor adjustments necessary. Burner flames should be
blue and stable with no yellow tips, excessive noise or lifting. Yellow flames indicate insufficient air.
Noisy flames or flames that lift away from the burner indicate too much air (See the “Flame
Characteristics” section on page 22).
TO LIGHT THE ROTISSERIE BURNER
1. Open the lid, push and turn rear burner knob slowly to “IGNITE/ON” setting; simultaneously press the
electronic ignition button to light the burner.
2. Once the burner is lit, release the electronic ignition button and knob.
3. If ignition does not occur in 5 seconds, turn the knob to “OFF”, wait 5 minutes and then repeat the
lighting procedure or light by match.
TO LIGHT THE SEARING SIDE BURNER
1. Push and turn sear burner knob slowly to “IGNITE/ON” setting; simultaneously to press the electronic
ignition button to light the burner.
2. Once the burner is lit, release the electronic ignition button and knob.
3. If Ignition does not occur in 5 seconds, turn the knob to “OFF”, wait for 5 minutes and then repeat the
lighting procedure or light by match.
To Match Light the Grill
If the burner will not light after several attempts using the control knobs, the burners may be lit with a match.