Perfect Flame GSC3318 - Grill Assembly Instructions

Assembly Instructions
Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is
fully assembled, go back and check to make certain all the bolts are tight. Tighten again with the screwdriver provided if it is
necessary.
Estimated Assembly Time: It will take less than 40 minutes to assembly the grill.
Step 1
Note: Before beginning assembly, make
certain the wheels of the cart assembly are
locked.
Align the holes at the right side panel (1) with
the holes on the right side of the bottle holder
(2).
Screw a M6x12mm bolt (A) with a M6 washer
(E) into each pre-drilled hole.
Tighten by hand until secure.
Repeat the procedure for the left side panel (2).
Go back and tighten with the screwdriver
provided.
Step 2
Insert the pin on the bottom of the right door
(3-1) into the hole at the bottom of the cart
assembly.
Insert the pin on top of the right door in the cart
front beam.
Repeat the same procedure for the left door
(3-2).
GSC3318
7
Owner’s Manual