Control box. It is on the engine side of the box that the raw rpm is located. You can
attach a blue “Tee Tap” connector to this Gray wire, and attach the RPM sensor cable
end to this “Tee Tap” using a supplied spade connector.
(5) 2000 – 2002 Nautiques
Same as standard #1 above, except the rpm signal can be picked from the Gray wire
coming from the back of the tachometer.
(6) 2003 - 2005 Nautiques
Located behind the dash pod is a large wiring harness with a large white plug. The
Gray wire in this plug carries the raw rpm of the engine and has been brought to the
pod solely for the PerfectPass system. This gray wire is not connected to any gauge.
Use a blue “Tee Tap” connector or other splice method to attach the Gray wire on the
PerfectPass rpm sensor cable to this Gray wire in the harness. The Black wire (ground)
on the RPM Sensor cable can be attached to the black wire in this same boat harness.
Step 6. Your manual throttle should act and feel just the same as before PerfectPass was installed.
If it does not feel normal, inspect throttle and linkage connection, particularly the brass hex
nut adjustment.
For assistance call (902) 468-2150.
To Next Page
Loading...