Performance Tool MaxiScan MS300 User Manual

14
 Not RDY(NOT READY) – indicates that a particular monitor being
checked has not completed its diagnostic testing
 N/A – the monitor is not supported on that vehicle
 → – a flashing Right Arrow indicates additional information is available
on the next screen
 ← – a flashing Left Arrow indicates additional information is available
on the previous screen
1. Select “3. I/M” from the main menu by pressing the ENTER
button.
 If the Scan Tool is not connected yet, then refer to “Read
Codes” from 1 to 6.
2. Use the SCROLL button to view the status of the MIL light (ON or
OFF) and the following monitors
 MISFIRE – Misfire monitor
 FUEL – Fuel System Monitor
 CCM – Comprehensive Components Monitor
 CAT – Catalyst Monitor
 HCM – Heated Catalyst Monitor
 EVAP – Evaporative System Monitor
 2AIR – Secondary Air Monitor
 A/C – A/C system Monitor
 O2S – O2 Sensors Monitor
 HO2S – O2 Sensor Heater Monitor
 EGR – EGR System Monitor
3. Press the ENTER button to return to the main Menu.
View VIN Number
The View VIN function allows you to retrieve the Vehicle Identification No.
on 2002 and newer vehicles that support Mode 9.
1. Select “4. VIN” from the main menu by pressing the ENTER
button.

Performance Tool MaxiScan MS300 Specifications

General

Brand	Performance Tool
Model	MaxiScan MS300
Category	Diagnostic Equipment
Language	English