Your Wilmar hydraulic jack was constructed with quality materials and
workmanship and will give you many years of trouble free use when
cared for as described in the "Care & Maintenance" section on page 3.
However, as with any mechanical device, periodic adjustments are
necessary to maintain a peak level of performance. Should your jack be
displaying any of the following symptoms, the simple procedures shown
below will correct the problem.
TROUBLESHOOTING
Read these safety warnings before operation.
WARNING!
Failure to heed these warnings may result in loss of load,
damage to jack, and/or jack failure resulting in personal injury
or property damage.
WARNING!
This is a lifting device only. Do not move load while it is on the
jack. Load must be supported immediately by Jack Stands or
other appropriate means.
Do not overload jack beyond rated capacity. Overloading can
cause damage to or failure of the jack.
REFER TO YOUR VEHICLE OWNERS MANUAL FOR PROPER
JACKING PROCEDURES. Lift only on areas of the vehicle as
specified by the vehicle manufacturer.
This jack is designed for use only on hard level surfaces
capable of sustaining the load. Use of jack on other than hard
level surfaces can result in jack instability and possible loss of
load.
Be sure all personnel are clear of load before lowering load.
Ensure that no personnel pass underneath load until load is
securely supported by jack stands
SPECIFICATIONS
Capacity: .................... 4,000 lbs.
Low Height: ...................... 5-1/4”
Max. Height: ................... 15-1/2”
Lift Range: ........................ 9-7/8”
Specifications are subject to
change without notice
IMPORTANT SAFETY INFORMATION
Check out the collection of automotive tools we offer.
To Previous Page
Loading...
Need help?
General
