Performance Tool W1633 - User Manual

8 pages

Save Page as PDF

To Next Page

20 TON HYDRAULIC BOTTLE JACK

OWNER’S MANUAL

Item Number W1633

WARNING

It is the owner and/or operators’ responsibility to study all WARNINGS, operating, and maintenance

instructions contained on the product label and instruction manual prior to operation of this hydraulic bottle

jack. The owner/operator shall retain product instructions for future reference.

The owner and/or operator are responsible for maintenance, maintaining all decals or warning labels and

while in use, maintaining the unit in good working order. If the owner and/or operator are not fluent in English,

the product warnings and instructions shall be read and discussed with the operators’ native language by the

purchaser/owner or his designee. Make sure that the operator comprehends its contents. Safety information

shall be emphasized and understood prior to usage. The hydraulic bottle jack shall be inspected per the

operating instructions.

Users of this hydraulic bottle jack must fully understand these instructions. Each person operating this

hydraulic bottle jack must also be of sound mind and body and must not be under the influence of any

substance that might impair their vision, dexterity, or judgment.

Protect yourself and others by observing all safety information.

Failure to comply with instructions could result in personal injury and/or property damage!

If you encounter any problems or difficulties, please contact our customer service department at:

1-800-426-1262 between 6:30 a.m. and 4:30 p.m. Pacific time.

Main Page

Questions and Answers

K
kaylacooperJul 28, 2025
How to fix a Performance Tool Jack that will not lift to full height?
- E
  Erika FloresJul 28, 2025
  If your Performance Tool Jack isn't reaching its full height, it could be due to a few reasons. First, the power unit might be low on fluid. To fix this, make sure the jack is on a level surface and in the down position. Then, remove the filler plug and add clean hydraulic jack fluid until it reaches the filler level. Another possibility is that the power unit is air bound. In that case, open the release valve at least two full turns and pump the handle at least 20 times to purge the air. Finally, the valve may not be closing completely. To seat the valves, close the release valve, manually raise the lifting arm as high as possible with the jack in the fully lowered position, and then open the release valve to let the jack descend.
J
James MorseAug 12, 2025
What to do if the Performance Tool W1633 Jacks pump feels spongy under load?
- G
  gonzalezjasmineAug 12, 2025
  If the pump on your Performance Tool Jack feels spongy when under load, it might be air bound. Try opening the release valve a minimum of 2 full turns and then pump the handle a minimum of 20 full strokes to purge any air from the system. Alternatively, the valve may not be closing completely. To resolve this, close the release valve, manually raise the lifting arm as high as possible while the jack is in the fully lowered position, and then open the release valve to allow the jack to descend.