2
SAFETY GUIDELINES / DEFINITIONS
UNPACKING AND INSPECTION
SPECIFICATIONS
Specifications are
subject to change
without notice.
Voltage ...........................................................................24 Volt
Drive Size ....................................................................... 1/2 in.
Impacts/Min. ...................................................... 0 - 4,000 BPM
Max Torque ..............................................................240 ft./lbs.
Charger Input ............................................120 Volts AC 60HZ
Charging Time .............................................................3-5 hrs.
Battery Type ................................................. Nickel Cadmium
WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or
maintain this product. Failure to comply with the instructions may result in serious personal injury and/or property
damage!
The following signal words are used to emphasize safety warnings that must be followed when using this
product:
This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and
troubleshooting steps described within to ensure your safety and satisfaction. The contents of this instruction manual are
based upon the latest product information available at the time of publication. The manufacturer reserves the right to make
product changes at any time without notice.
DANGER Indicates an imminently hazardous
situation that, if not avoided, WILL result in death or
serious injury.
WARNING Indicates a potentially hazardous
situation that, if not avoided, COULD result in death
or serious injury.
CAUTION Indicates a potentially hazardous situation
that, if not avoided, MAY result in minor or moderate
injury.
NOTICE Indicates important information, which if not
followed, MAY cause damage to equipment.
After opening the carton, unpack your new product and related parts & accessories. Please inspect it carefully for
any damage that may have occurred during transit. Please check it against the photograph on carton. If any parts
are missing, please call customer service at 1-800-426-1262 between 6 a.m. and 5 p.m. Pacific time.
WARNING DO NOT operate this product if damaged during shipment, handling or misuse. Do not operate the
product until the parts have been replaced or the fault rectified. Failure to do so may result in serious personal injury
or property damage. All damaged parts must be repaired or replaced as needed prior to operating this product.
Check to see that all nuts, bolts and fittings are secure before putting this product into service. If you have any
questions, or require assistance with damaged or missing parts, please contact our factory customer service
department at: 1-800-426-1262.
Please have the serial number, model number, and date of purchase available for reference when calling.
IMPORTANT SAFETY INFORMATION
WARNING
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE OPERATING THIS
PRODUCT. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND
WILL VOID WARRANTY.
1. Always use common sense and pay particular
attention to all the DANGER, WARNING, CAUTION
and NOTICE statements of this manual. The safety
instructions provided are not intended to cover all
possible conditions and practices that may occur
when operating, maintaining and cleaning power
tools.
2. Observe work area conditions. Do not use machines
or power tools in damp or wet locations. Don’t
expose to rain. Keep work area well lighted. Do not
use electrically powered tools in the presence of
ammable gases or liquids. Do not bring combustible
materials near the tools. Power tools create sparks,
which may ignite the dust or fumes. Keep work
area clean and well lit. Cluttered work areas invite
accidents.
3. Use personal protective equipment. Wear ANSI
approved safety goggles. Protective equipment
such as dusk mask, non-skid safety shoes, hard hat,
heavy duty work gloves or hearing protection used for
To Next Page
Loading...
Need help?
General
