7
FORWARD / REVERSE AND TRIGGER LOCK LEVER:
NOTICE
Be sure the trigger is released when
changing the position of the lever. Always store the
tool in the “LOCKED/OFF” position. Always check
the direction of the Cordless Impact Wrench’s rota-
tion before use.
• To select forward Cordless Impact Wrench rotation,
press the trigger lock from left to right at against the
Cordless Impact Wrench body.
• To select reverse, press the trigger lock lever in the
opposite direction.
• The center position locks the tool.
OPERATION
Lock
Lever
CARE & MAINTENANCE
WARNING
Always remove the bat-
tery pack before attempting cleaning or
maintenance.
NOTICE
This Cordless Impact Wrench
is lubricated before it leaves the factory.
This lubrication should last for the life of
the tool. No further lubrication is required.
Use only mild soap and a damp cloth to clean
the tool. Never let any liquid get inside the
casing. Never immerse any part of the tool in
a liquid. Always keep the ventilation openings
clear.
Always clean the battery pack using only a dry
cloth. Do not use liquids.
Always unplug the charger before cleaning it.
Regularly clean the ventilation slots in your tool
and charger using only a soft brush or dry cloth.
Never open the Cordless Impact Wrench case,
battery pack or charger. Do not attempt to repair
the Cordless Impact Wrench, battery pack or
charger yourself. Opening any of these parts will
void your warranty.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model. Acces-
sories that may be suitable for one tool may become hazardous when used on another
tool.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets. If you
must use an extension cord, be sure that the gauge is large enough to carry the amount
of current necessary for your power tool. If not, your tool may experience a loss of power,
excessive voltage drop or overheating. The smaller the gauge number, the heavier the
cord (see table below).