Performance Tool W50054 User Manual

Amps: 0.92
Volts: 120VAC ~ 60HZ
Free Speed: 3,000 RPM
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Alert . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Unpacking & Inspection . . . . . . . . . . . . . . . . . . . . . . 2
Safety Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Tool Use & Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Random Orbital Buffer Features . . . . . . . . . . . . . . . 5
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Care & Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . 7
Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . . 7
Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . 8
The Performance Tool 10” Random Orbital Buffer is designed for polishing, waxing, and buffing. Powered by a durable 0.92 Amp motor, the random
orbiting mechanism delivers 3,000 operations per minute (OPM), mimicking the motion of circular hand polishing. Dual hand grips provide added control.
Designed for years of trouble-free use, it will tackle your automotive finish maintenance applications with ease.
This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and troubleshooting steps described
within to ensure your safety and satisfaction. The contents of this instruction manual are based upon the latest product information available at the time of
publication. The manufacturer reserves the right to make product changes at any time without notice.
WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or maintain this
random orbital buffer. Failure to comply with the instructions may result in serious personal injury and/or property damage!
The following signal words are used to emphasize safety warnings that must be followed when using this random orbital buffer:
DANGER
Indicates an imminently hazardous situation that, if not avoided, WILL result in death or serious injury.
WARNING
Indicates a potentially hazardous situation that, if not avoided, COULD result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that, if not avoided, MAY result in minor or moderate injury.
NOTICE
Indicates important information, which if not followed, MAY cause damage to equipment.
After opening the carton, unpack your new random orbital buffer and related parts & accessories. Please inspect it carefully for any damage that may
have occurred during transit. Please check it against the photograph on carton.
WARNING
Do not operate this random orbital buffer
if damaged during shipment, handling or misuse. Do not operate the tool until the parts
have been replaced or the fault rectified. Failure to do so may result in serious personal injury or property damage.
All damaged parts must be repaired or replaced as needed prior to operating this tool.
SPECIFICATIONS
WARNING: When using tools basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
UNPACKING & INSPECTION
SAFETY ALERT
INTRODUCTION
TABLE of CONTENTS
2.

Performance Tool W50054 Specifications

General

Brand	Performance Tool
Model	W50054
Category	Sander
Language	English