NOT be modified and/or used for any application other than for which it was designed. If you have any questions relative to its
application DO NOT use the tool until you have written Wilmar Corporation and we have advised you.
Technical Service Manager
Wilmar Corporation
350 Midland Drive
Tukwila, WA 98188
EXTENSION CORD SELECTION
Replace damaged extension cords immediately. Use of damaged extension cords can shock, burn or electrocute.
If an extension cord is used, make sure the conductor size is large enough to prevent excessive voltage drop which will cause loss of
power and possible motor damage. A table of recommended extension cord sizes will be found in this section. This table is based on
limiting line voltage drop to 5 volts for 115 volts at 150% of rated amperes. If an extension cord is to be used outdoors it must be
marked with the suffix W-A or W following the cord type designation. For example – SJTW-A to indicate it is acceptable for outdoor use.
1. Motor housing
2. ON/OFF Switch
3. Handles
4. Foam backing pad
5. Terrycloth bonnet
6. Synthetic wool polishing bonnet
ASSEMBLY
The Performance Tool orbital buffer is packaged and shipped fully assembled.
Be sure to follow the below instructions before each use.
Switching on and off:
1. Hold tool by both handles.
2. Using your thumb, push the ON/OFF switch (2) on the right handle to the ON ("I") position.
3. To turn off, push the switch to the OFF ("O") position.
APPLICATIONS
The Performance Tool Random Orbital Buffer can be used to polish and buff most high-gloss surfaces. The terrycloth application bon-
net and synthetic wool buffing bonnet are manufactured to apply and remove polishes and waxes. Common applications include: cars,
boats, aircraft, hardwood floors, furniture and more.
PREPARING THE SURFACE
Before you begin, make sure that the surface is clean and dry. The work area must also be dry. Most high-gloss surfaces can be
cleaned with a mild soap and water solution. If necessary, remove stubborn dirt such as road tar, grease and bug stains with a cleaning
product designed for this purpose.
10" RANDOM ORBITAL POLISHER/BUFFER FEATURES
OPERATION
RECOMMENDED EXTENSION CORD SIZES FOR USE WITH PORTABLE ELECTRIC TOOLS
Length of Cord in Feet
115V 25 Ft. 50 Ft. 100 Ft. 150 Ft. 200 Ft. 250 Ft. 300 Ft. 400 Ft. 500 Ft.
0-2A 18 18 18 16 16 14 14 12 12
2-3A 18 18 16 14 14 12 12 10 10
3-4A 18 18 16 14 12 12 10 10 8
4-5A 18 18 14 12 12 10 10 8 8
5-6A 18 16 14 12 10 10 8 8 6
6-8A 18 16 12 10 10 8 6 6 6
8-10A 18 14 12 10 8 8 6 6 4
10-12A 16 14 10 8 8 6 6 4 4
12-14A 16 12 10 8 6 6 6 4 2
14-16A 16 12 10 8 6 6 4 4 2
16-18A 14 12 8 8 6 4 4 2 2
18-20A 14 12 8 6 6 4 4 2 2
5.
Motor Housing
Handles
Foam Backing Pad
Terrycloth Bonnet or
Synthetic Wool
Polishing Bonnet
ON/OFF
Switch
To Next Page
Loading...
Need help?
General
