Specific safety rules for the cut-off saw
WARNING: Do not operate the saw until it is completely assembled and installed
according to the instructions.
1. If you are not thoroughly familiar with the operation of a cut-off saw, obtain advice from a
supervisor, instructor, or other qualified person.
2. ALWAYS WEAR SAFETY GOGGLES. Wear hearing protection during periods of extended
operation.
3. REPLACE A CRACKED METAL CUTTING DISC IMMEDIATELY. Handle the disc
carefully and inspect it for cracks before each use. Tighten the spindle bolt enough to hold the
disc firmly. Use only the disc flanges provided with your cut-off saw.
4. DO NOT stand in front of the cut-off saw when starting it. To start the saw, stand to one side,
turn on the saw, and wait until the saw reaches full speed. There is always the possibility that a
piece from a damaged disc may be thrown off when coming to full speed.
5. ONLY USE abrasive cut-off discs rated at 4100 RPM or higher.
6. DO NOT use a circular saw blade or tooth-type blade in the cut-off saw.
7. DO NOT cut wood with this cut-off saw.
8. DO NOT use the cut-off saw with the upper or lower blade guard removed.
9. ALWAYS CLAMP THE WORKPIECE with the vise-clamp assembly when cutting.
10. CAUTION! Flying sparks will occur when cutting. Sparks can cause personal injury and ignite
flammable materials.
11. DO NOT TOUCH the workpiece after cutting. It is hot and could burn the skin.
12. Release the trigger switch and allow the cutting disc to come to a complete stop before
removing anything from the cut-off saw table.
13. Keep your hands away from rotating parts.
14. AVOID DANGEROUS CONDITIONS. Do not use the cut-off saw in wet or damp areas, or
expose to rain. Use the cut-off saw in a well-ventilated area. This tool is for indoor use only.
5
To Next Page
Loading...
Need help?
General