Perkin-Elmer Lambda 365 User Manual

09931251D
PerkinElmer, 710 Bridgeport Avenue,
Shelton, CT06484-4794, U.S.A
Produced in the USA.
Lambda 365 Water Jacketed 8-Position Multi-Cell Holder
Installation Instructions
This instruction sheet describes the installation of this accessory which is used with the Lambda 365
Spectrophotometer.
NOTE:
Read these instructions before you install this accessory.
Contacting PerkinElmer
Supplies, replacement parts, and accessories can be ordered directly from PerkinElmer, using the part
numbers.
See our website:
http://perkinelmer.com
PerkinElmer's catalog service offers a full selection of high-quality supplies.
To place an order for supplies and many replacement parts, request a free catalog, or ask for information:
If you are located within the U.S., call toll free 1-800-762-4000, 8 a.m. to 8 p.m. EST. Your order will be
shipped promptly, usually within 24 hours.
If you are located outside of the U.S., call your local PerkinElmer sales or service office.
Features
• Suitable size for the standard cells
• Excellent durability
• Controls the temperature by circulation of liquid
Figure 1 Lambda 365 Water Jacketed 8-Position Multi-Cell Holder [P/N: N4101006]

Perkin-Elmer Lambda 365 Specifications

General

Wavelength Range	190 - 1100 nm
Power Requirements	100-240 VAC, 50/60 Hz
Photometric Accuracy	±0.002 Abs (at 1 Abs)
Baseline Stability	< 0.0005 Abs/hour
Light Source	Deuterium and Tungsten-Halogen lamps
Display	Touchscreen
Photometric Repeatability	± 0.001 Abs

Summary

Installation Instructions

Contacting PerkinElmer

Information on ordering supplies, replacement parts, and accessories from PerkinElmer, including website and contact numbers.

Features

Highlights key attributes of the multi-cell holder, such as size, durability, and temperature control.

Dimensions and Specifications

Dimensions

Provides physical measurements for the outline and inner dimensions of the multi-cell holder, along with its weight.

Specifications

Details technical specifications including space between cells, moving distances, and moving times.

Environmental Conditions for Operation

Specifies the operating temperature range and method for temperature control using a circulator.

Configuration of Water Jacketed 8-Position Multi-Cell Holder

Installation

Measurement

Calibration of Multi-Cell Position

Troubleshooting

When liquid leakage occurs

Guidance on diagnosing and resolving issues related to liquid leaks at fittings, between mounts and tubes, or holders.

When constant temperature is not maintained

Steps to check circulator function, temperature maintenance, and tube connections for consistent temperature.

When the tube frequently becomes detached

Recommendations for fixing tube detachment issues, including replacing aged tubes and using Teflon tape.

When the Multi-Cell does not move

Troubleshooting steps for when the multi-cell holder fails to move, focusing on connector port checks.

When the intensity value is low

Instructions for recalibrating the multi-cell or replacing the lamp if low intensity values persist.

When the Multi-Cell does not reset

Guidance for resetting failures, suggesting replacement of the photo interrupter switch.