What to do if sensor position not reached during autocalibrating the sensor position in PerkinElmer DSC 4000?
If the sensor position is not reached during autocalibration, check the DSC lower lid position, as the vertical stepper may have missed steps due to being blocked while running at slow speed.
What to do if there is no link between DSC and AS 6000 via I2C in PerkinElmer DSC 4000 Measuring Instruments?
If there is no link between the DSC and AS 6000 via I2C, replace the I2C cable, as the connection cable may be defective.
General| Brand | PerkinElmer |
|---|---|
| Model | DSC 4000 |
| Category | Measuring Instruments |
| Language | English |
Provides information on the installation of the PerkinElmer Thermal Analysis System and Pyris software.
Covers electrical warnings, EMC compliance, electrical safety, and WEEE disposal.
Specifies electrical, environmental, and space requirements for laboratory setup.
Outlines essential safety measures to be followed before and during DSC 4000 operation.
Outlines the sequential steps required for installing the DSC 4000 system.
Covers troubleshooting common errors and performing routine maintenance on the autosampler.
To Next Page