Perkins 1204F-E44TA - Page 46

(Table 5, contd)
Inducement Time
First Occurrence
None 36 Hours 64 Hours 50 Percent torque
Shut down or idle
Until fault heals
Cycling the keyswitch
will give 20 minutes
of full power
The system must be fault free for 40 hours before the system will reset to zero. If the fault is intermittent, and returns within the 40 hours, then
the repeat occurrence inducement time will be triggered.
The override can only be used once
Inducement Time
Repeat Occurrence
None None 5 Hours 50 Percent torque
Shut down or idle
Until fault heals
Cycling the keyswitch
will give 20 minutes
of full power
Inducement None None 75 Percent of torque
Notification None Emission malfunction
lamp will be on solid
Emission malfunction
lamp will flash
Emission malfunction
lamp will flash
The stop lamp will be
on solid
Emission malfunction
lamp will flash
Contact your Perkins dealer or your Perkins Distributor at level 1 warning, do not let the fault develop.
46
SEBU9063-07
Operation Section
Selective Catalytic Reduction Warning System