This document is printed from SPI². Not for RESALE
Illustration 46 g02879436
Typical example
7. If necessary, remove the low-pressure fuel line
from the retaining clips. Remove the tube
assembly (1) from the inlet of the fuel transfer
pump.
Note: Ensure that the low-pressure fuel lines are not
deformed.
Illustration 47 g02895617
Typical example
8. Install Tooling (A) to the inlet of the fuel transfer
pump and the end of tube assembly (1). Ensure
that Tooling (A) is secured and clear of rotating
parts.
9. Prime the fuel system. Refer to Operation and
Maintenance Manual, “Fuel System - Prime” for
the correct procedure.
UENR0623 51
Fuel System
To Next Page
Loading...
