Perkins 854F-E34T - Flywheel Housing - Inspect

This document is printed from SPI². Not for RESALE
Flywheel Runout
Illustration 71 g01321858
Typical example
1. Install Tooling (A) in illustration 71 , as shown.
2. Set the pointer of the dial indicator to 0 mm
(0 inch).
3. Turn the flywheel. Read the dial indicator for every
45 degrees.
4. Calculate the difference between the lowest
measurement and the highest measurement of the
four locations. This difference must not be greater
than 0.30 mm (0.012 inch).
i02406200
Flywheel Housing - Inspect
Table 12
Required Tools
Tool
Part
Number
Part Description
Qty
A
21825617
Dial Gauge 1
Concentricity of the Flywheel
Housing
Note: This check must be made with the flywheel and
the starter removed and the bolts for the flywheel
housing tightened lightly.
Illustration 72 g01199468
Typical example
1. Install Tooling (A). See illustration 72 .
2. Set the pointer of the dial indicator to 0 mm
(0 inch).
3. Check the concentricity at intervals of 45 degrees
around the flywheel housing.
4. Calculate the difference between the lowest
measurement and the highest measurement. This
difference must not be greater than the limit that is
given in Table 13 .
Note: Any necessary adjustment must be made on
the flywheel housing. Then, recheck the concentricity.
Alignment of the Flywheel Housing
Note: This check must be made with the flywheel and
the starter removed and the bolts for the flywheel
housing tightened to the correct torque.
78 UENR0623
Basic Engine