This document is printed from SPI². Not for RESALE
If you inspect the engine in operation, always use the
proper inspection procedure in order to avoid a fluid
penetration hazard . Refer to Operation and
Maintenance Manual, “General hazard Information”.
If the engine will not start, refer to Troubleshooting,
“Engine Cranks but will not Start”.
i05241801
Fuel System Pressure - Test
Table 4
Required Tools
Tool Part Number
Part Description Qty
A
-
Pressure gauge
(1)
1
B T400138 Pressure test kit 1
(1)
Pressure gauge needs to be able to measure pressure in a
vacuum.
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorized personnel that have the correct
training.
Before beginning ANY work on the fuel system,
refer to Operation and Maintenance Manual, “Gen-
eral Hazard Information and High Pressure Fuel
Lines” for safety information.
Refer to Systems Operation, Testing and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of clean-
liness that must be observed during ALL work on
the fuel system.
Note: Ensure that the engine is stopped before
installing and removing Tooling (A) and (B) or carrying
out any repair work on the fuel system.
UENR0623
55
Fuel System
To Next Page
Loading...
