This document is printed from SPI². Not for RESALE
Flywheel Housing - Inspect ............................. 78
Alignment of the Flywheel Housing.............. 78
Concentricity of the Flywheel Housing......... 78
Fuel Injection ................................................... 21
Components of the Fuel Injection System ... 25
Fuel Injectors ............................................... 28
Fuel Manifold ............................................... 28
Fuel Pump Assembly................................... 26
High Pressure Fuel System ......................... 24
Introduction .................................................. 21
Primary Filter/Water Separator .................... 25
Secondary Fuel Filter................................... 25
Fuel Injection Timing - Check .......................... 52
Fuel Quality - Test............................................ 53
Fuel System..................................................... 50
Fuel System - Inspect...................................... 50
Fuel System - Prime ........................................ 54
Fuel System Pressure - Test............................ 55
G
Gear Group - Inspect ....................................... 79
Gear Group (Front) - Time ............................... 58
General Information........................................... 4
Glossary of Electronic Control Terms .............. 45
I
Important Safety Information ............................. 2
Increased Engine Oil Temperature - Inspect ... 69
Introduction........................................................ 4
L
Lubrication System .....................................19, 68
P
Piston Height - Inspect..................................... 76
Piston Ring Groove - Inspect........................... 74
Inspect the Clearance of the Piston Ring..... 74
Inspect the Piston and the Piston Rings ...... 74
Inspect the Piston Ring End Gap................. 75
Position the Valve Mechanism Before
Maintenance Procedures............................... 74
Power Sources ................................................ 41
ECM Power Supply...................................... 42
Introduction .................................................. 41
Power supply for the Glow plugs.................. 45
Power Supply for the Pressure Sensors...... 43
S
Systems Operation Section............................... 4
T
Table of Contents............................................... 3
Testing and Adjusting Section ......................... 50
Turbocharger - Inspect .................................... 59
Inspection of the Compressor and the
Compressor Housing ................................. 60
Inspection of the Turbine Wheel and the
Turbine Housing......................................... 60
Inspection of the Wastegate......................... 61
V
V-Belt - Test ..................................................... 84
Valve Depth - Inspect....................................... 65
Valve Guide - Inspect....................................... 66
W
Water Pump - Inspect ...................................... 73
Water Temperature Regulator - Test................ 73
90 UENR0623
Index Section
To Next Page
Loading...
