TPD 1399E Chapter 1
Page 1
Engine mounting
Installation angles
The engine is intended to be installed so that the
cylinders are vertical, when viewed from ahead or
astern (A).
In service, however, the sump tted as standard on the
M65 and as an option on the M85T (B) may operate
continuously at a heel angle of 20
O
, and intermittently
(i.e. for up to 15 seconds at a time) at an angle of
25
O
.
A high inclination sump tted as standard on the M85T,
and as an option on the M65, allows an operating
heel angle of 25
O
continuously, and intermittently up
to 35
O
(C).
To Next Page
Loading...
