Chapter 1 TPD 1399E
Page 2
Installation angles (continued)
The engine is suitable for installation so that in side
view the crankshaft is horizontal, or ‘ywheel down’ to
a maximum of 17
O
(A).
An allowance has been made for an additional 3
O
rise
to occur in service, when climbing waves or starting
to plane.
Engine mounting brackets
The standard brackets provide mounting points which
are 35mm below, and parallel with, the crankshaft
centre line (B1).
The brackets may be used to mount the engine
directly on to engine bearers, but for all applications it
is recommended that exible engine mounts are used
(B2).
Engine mounting brackets are available for transverse
mounting centres of either 460mm or 550mm (C1).
In both cases the longitudinal mounting centres are
654mm (C2).
To Next Page
Loading...
