6
IDS-710 Hardware Installation Guide
Power Connector
The power input connector has provisions for dual inputs. Two independent power
sources can be used to power the switch. If one power input fails, the other power input
will power the switch.
See - Terminal Block Connectors
Alarm Relay Connector
The Alarm Relay can be energized by the software or hardware under certain conditions.
It can then be used to trigger an external alarm circuit such as a light or sounding device.
This connector provides a Normally opened (NO) dry contact on the connector block.
Digital Input Connector
A Digital Input is provided. It can be used for the generation of alarms (SNMP trap, ener-
gizing of on board Alarm Relay etc.).
Port Status Indicators
Ethernet Port Status Indicators
Port Link / Speed
State Description
LED 1: Green LED 2: Off 1000 Mbps
LED 1: Green LED 2: Green 100 Mbps
LED 1: Off LED 2: Green 10 Mbps
On solid Port Link
Random blinking Port Link and Activity
Slow blinking Error disabled
Rapid blinking Port in Fast Setup Mode
To Next Page
Loading...