02
01
3A-1
3A-2
Position the wall plate [01] and [02]
at your desired height and line up
the holes with your stud center line.
Level the wall plate [01] and [02]
and mark the holes.
24” (610mm
)
16
” (
406mm
)
Use a stud finder (NOT included) to
locate wood studs or use an awl
(NOT included) to verify the edges.
Mark the edge and center locations.
Awl
(NOT lncluded)
Stud Finder
(NOT lncluded)
OR
OR
3A-3
ø7/32
”
(5.5mm)
2 3/4
”
(70mm)
Drill 4 pilot holes using a 7/32
”
(
5.5mm) diameter drill bit. Make
sure the depth is NOT less than 2
3/4
” (
70mm).
Drill
(NOT lncluded)
Pencil
(NOT lncluded)
05 07 08 09
To Next Page
Loading...
