Owner’s Manual Permobil K/C300 Design and function, R-net
44
R-Net control panel LCD monochrome display
Fault
The control system can detect a wide variety of
errors. When the system has detected an error that
is not severe enough to cause the system to trip,
then this symbol will be displayed.
Motor Temperature
This symbol is displayed when the control system
has intentionally reduced the power to the motors, in
order to protect them against heat damage.
Control system Temperature
This symbol is displayed when the control system
has intentionally reduced its own power, in order to
protect itself against heat damage.
Timer
This symbol is displayed when the control system
is changing between different states. An example
would be entering into Programming Mode. The
symbol is animated so that you can see the sand
running through the hourglass.
E-Stop
If the control system is programmed for latched
operation, then it is normal for an Emergency Stop
Switch to be connected into the External Profile
Switch Jack. If the Emergency Stop Switch is
operated or disconnected, this symbol will flash.
To Next Page
Loading...
