Permobil K - Page 96

Owner’s Manual Permobil K/C300 Troubleshooting
97
R-net diagnostics
When an error or a fault occurs in the wheelchair’s electronics, information about
the fault is displayed in the control panel’s display. This information can then be
used to diagnose where the error/fault occurred and its cause.
Troubleshooting and repairs must always be performed by competent person-
nel with good knowledge of the wheelchair’s electronics. More information
on troubleshooting and remedies can be found in the Service Manual for this
wheelchair model.
Diagnostic screens
Current diagnostic screen
When the control system’s integrated protection circuits have been triggered
so that the control system can no longer operate the wheelchair, a diagnostic
screen is displayed in the control panel’s display.
This indicates a system fault, i.e. R-net has detected a problem somewhere in
the wheelchair’s electrical system.
NOTE! If the fault is in a module that is not currently being used, it may still be
possible to drive the wheelchair, but the diagnostic screen is displayed occa-
sionally.
Switch off the wheelchair and leave it off for a few minutes. Then restart the
wheelchair. If the fault persists, you must switch off the wheelchair and con-
tact your service provider. Write down the information displayed in the control
panel’s display and pass it on to your service provider.
Do not use the wheelchair until the problem has been remedied or you have
received other instructions from your service provider.
Diagnostics should only be performed by persons with sound knowledge of the wheelchair’s
electronic control system. Incorrect or poorly performed repairs may make it dangerous to use the
wheelchair. Permobil accepts no liability for any personal injury or damage to the wheelchair and
its surroundings that occurs on account of incorrect or poorly performed repair work.
m
WARNING