Permobil K - Page 97

Owner’s Manual Permobil K/C300 Troubleshooting
98
Example of a screen showing a system fault
Identified module
This indicates the control system module that detected the problem.
PM= Power module
JSM= Joystick module
Error message
The error message provides a brief description of the error type.
Error code
The four-digit code indicates which protection circuit has been triggered.
PM
Low Battery
2C00
Error code
Identified module
Error message
PM
0506
Controller Fault
Repair of defective units
Apart from specific OEM-approved spare parts (contact your service provider or
Permobil for further information on these), there are no replaceable parts in the
R-net control system. Consequently, defective units must be sent to Permobil or
a Permobil-approved service center for repair.
m
CAUTION
If any part is replaced without Permobil’s approval, the wheelchair’s warranty may be void.
Permobil accepts no liability for any loss that occurs as a a result of a component of the R-net
control system being opened, adjusted or modified without permission.