PART 8: MAINTENANCE AND SERVICE
PB1319 (CAT. NO. 5296 ) —111— 22-01691 (R02/02)
Electrical &
lights
Reverse lights Visual check. X
Alternator Check operation and output. X
Alternator Check tightness of the pulley nut. X
Alternator Check the tension of the drive belt (see page 153
). X
Alternator Check tightness of the terminal hex nuts. X
Starter Check torque on hex nuts. X
ECM connector Check the tightness of the ECM connector. X
Wheel sensors
Check for damaged sensors and connectors, and worn or frayed wires.
X
Fuel tank sending unit Check the mounting screws and electrical connections for worn or
damaged wires and connectors.
XX
Power supply harnesses
(engine, transmission, etc.)
Check for worn or damaged insulation, corroded terminals, frayed
wires, and oil or fluid leaks on the connectors or wiring.
X
Power supply harnesses
(engine, transmission, etc.)
Wash to remove excess grease. X
Cab struc-
ture, doors,
& hoods
Hood Lubricate the lower hood pivot (only if lube fittings are present). X
SYSTEM COMPONENT MAINTENANCE TASK
Recommended
PM Interval
I ABCDE
To Next Page
Loading...
