PART 8: MAINTENANCE AND SERVICE
PB1319 (CAT. NO. 5296 ) —110— 22-01691 (R02/02)
Driveshafts Models SPL-140XL/
170XL/250XL slip mem-
bers and U-joints (OFF
HIGHWAY & CITY)
Lubricate. X
Battery
Boxes, Tool
Boxes, and
Steps
Battery cables Check the condition of the cables, cushion clamps, and routing.
Replace a cushion clamp if the rubber has deteriorated. Repair or
tighten terminals, and secure cables to prevent chafing. Replace
damaged cables (cuts, cracks, or excessive wear) (see page 144
).
XX
Batteries Check for cracks and damage, electrolyte level, condition of termi-
nals, and tightness of holddowns (see page 144
).
X
Battery box and tray Check the box integrity. Clean the drain tube and check for acid
leaks. Check condition of all equipment mounted under the box.
X
Electrical &
lights
Headlamps Check the aim and adjust as required. X
Warning lights in light bar Check at the ignition start position to verify bulbs function (see
page 48
).
X
Turn signal Visual check. X
Stop lights Visual check. X
SYSTEM COMPONENT MAINTENANCE TASK
Recommended
PM Interval
I ABCDE
To Next Page
Loading...
