PART 4: CONTROLS AND DISPLAYS
PB1319 (CAT. NO. 5296 ) —39— 22-01691 (R02/02)
e. Press & release the Reset switch; the minutes digits will stop
flashing. The alarm is now set and activated (the “*” symbol will
show in the clock display to indicate this).
-To turn the alarm OFF or ON, press & hold the Select switch for
3 seconds while viewing any display.
-To deactivate the buzzer when the alarm sounds, press &
release the Select switch. (Note: The alarm will automatically
deactivate after 60 seconds.)
Further use and operation of the SMC is covered in PART 7: START-
ING & OPERATING THE VEHICLE of this manual.
Tachometer
Your tachometer measures the engine speed in revolutions-per-
minute (RPM). Watching your tachometer is important to driving effi-
ciently. It will let you match driving speed and gear selection to the
operating range of your engine. If your engine speed gets too high,
you can select a higher gear to lower the RPM. If your engine speed
drops too low, you can select a lower gear to raise the RPM.
NOTE: When the ignition is OFF, the SMC will be in a
“sleep” (blank) mode. To “awaken” it, press the
“Select”
switch. The SMC will function normally while awake; it will
return to a “sleep” mode 20 seconds after a switch is last
pressed.
11244B
To Next Page
Loading...
