Peterbilt 320 - Page 40

To Next Page

To Previous Page

PART 4: CONTROLS AND DISPLAYS

PB1319 (CAT. NO. 5296 ) —38— 22-01691 (R02/02)

The odometer is normally displayed on the screen. To choose

another function, press and release the Select switch until it appears.

• The odometer reads miles & tenths; e.g., 123456.7

• The Trip 1 odometer reads miles & tenths; e.g., 1234.5T1

• The Trip 2 odometer reads miles & tenths; e.g., 1234.5T2

• The hourmeter reads in hours; e.g., 12345HR

• The clock reads in hours & minutes, with A.M. or P.M.indicated at

the end; e.g., _ _ 12:34A (or P).

• If the clock alarm is set and activated, the display will appear as

* _ 12:34A (or P).

• The clock alarm reads in hours & minutes, with A.M. or P.M. indi-

cated as shown; e.g., AL12:34A (or P).

To set or reset a function, follow the procedures below.

1. Turn the ignition switch to ON.

2. Choose the desired function.

3. Set or reset the function:

• Trip Odometers: Press and hold the Reset switch until the mile-

age is reset to zero; this will take about 3 seconds.

•Clock

a. Press & release the Reset switch; the hours digit will flash.

b. Press & hold the Select switch; the hours digits will increase

until the switch is released. Scroll through 12 hours to change

between A.M. and P.M.

c. Press & release the Reset switch; the hours digits will stop

flashing, and the minutes digits will begin to flash.

d. Press & hold the Select switch; the minutes digits will increase

until the switch is released.

e. Press & release the Reset switch; the minutes digits will stop

flashing. The clock is now set.

• Clock Alarm