PREVENTIVE MAINTENANCE SCHEDULE PART 8: MAINTENANCE AND SERVICE
– 124 – Y53-6007 (R10/06)
Drive Axle
(Dana)
Breather Clean or replace. X
Lube Pump (ON HIGHWAY) Remove the magnetic strainer and inspect for wear particles. Wash in sol-
vent and dry in air.
X
Lube Pump (OFF HIGHWAY) Remove the magnetic strainer and inspect for wear particles. Wash in sol-
vent and dry in air.
X
Lube Filter (ON HIGHWAY) Change. X
Lube Filter (OFF HIGHWAY) Change. X
Magnetic drain plug and
breather (ON HIGHWAY)
Clean or replace.
X
Magnetic drain plug and
breather (OFF HIGHWAY)
Clean or replace.
X
Drive Axle
(Meritor)
Axle Housing Check the “cold” fill level at the differential carrier plug for a pinion angle of
less than 7 degrees, or at the axle bowl plug for a pinion angle of greater
than 7 degrees. Tighten the plug to 35 - 50 Lb. ft. (47 - 68 N.m.)
X
Axle Housing Visually inspect for damage or leaks. X
Table 2 Preventative Maintenance Schedule (Continued)
SYSTEM COMPONENT MAINTENANCE TASK
Recommended
PM Interval
I ABCDE
To Next Page
Loading...
