ELECTRICAL PART 8: MAINTENANCE AND SERVICE
– 180 – Y53-6007 (R10/06)
WARNING! When disconnecting jumper cables,
make sure they do not get caught in any moving
parts in the engine compartment.
7. Reverse the above sequence exactly when removing
the jumper cables. Take care that your first step is to
remove the cable from the chassis or ground of the
vehicle that was jump-started.
Removing and Installing Batteries
CAUTION: Always reinstall the battery com-
partment cover (step) before entering the cab.
Without the battery cover you could slip and
fall, resulting in possible injury to yourself.
Whenever you have to install a battery or remove one, fol-
low these guidelines for the safety of yourself and the bat-
tery.
• Ensure all switches on the vehicle are turned Off.
• Disconnect the ground cable first when removing a
battery.
• Connect the ground cable last when installing a bat-
tery.
Headlamp Adjustment
Follow the procedure below to adjust a headlamp.
NOTE: This lamp has provisions for vertical adjustment
only. Access the adjuster through the hole in the lens (see
the illustration below).
Optical Center
TORX #20
Vertical Adjustment
To Next Page
Loading...
