EasyManua.ls Logo

Peterbilt 387 - Page 7

Peterbilt 387
212 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PART 2: GETTING INTO & OUT OF THE CAB AND FRAME ACCESS DOOR LOCK AND KEYS
(R10/06) Y53-6007 – 9 –
Press the UNLOCK button once. The driver's door will
unlock and the parking lights will come on for 40 sec
-
onds.
To Unlock The Passenger’s Door
Press the UNLOCK button once and press again
within 5 seconds. The passenger door will unlock.
To Lock Both Doors
Press the LOCK button. The doors will lock and the
parking lights will come on for 2 seconds. If the doors
are open they will not lock. The range of the RKE sys
-
tem should be approximately 30 ft. This will be
reduced if it is operated close to other RF sources
such as TV/radio transmitters and cell towers.
Batteries
The key fob uses one CR2032, 3V battery. Batteries
should last approximately three years, depending on use.
Consistently reduced range is an indicator that the battery
needs replacement. Batteries are available at most dis
-
count, hardware and drug stores.
To Replace The Battery
1. Remove rear cover from key fob.
2. Remove the battery.
3. Install new battery.
4. Reinstall cover.
5. Synchronize the key fob.
Synchronization
The key fob may need to be synchronized to the truck
when the battery is replaced or when the key fob has not
been used for an extended period time.
To Synchronize A Key Fob
1. Hold the key fob near the receiver.
NOTE: The receiver is located behind the
Speedometer/Tachometer cluster assembly.
2. Press and hold both the Lock and Unlock buttons at
the same time for approximately 7 seconds.
3. When the key fob is resynchronized, the doors will
lock then immediately unlock.
4. If the fob fails to synchronize, it could be programmed
to a different truck or could have failed. Contact your
dealer to re-program your key fob.

Table of Contents

Related product manuals