Petsafe ST-100 - Operating Guide; Prepare the Remote Transmitter

10 www.petsafe.net
FR ENES
NL
IT
DE
OPERATING GUIDE
STEP 1
Prepare the Remote Transmitter
To Insert and Remove the Battery
1. To remove, use the Test Light Tool or a coin and turn the battery
cover counter-clockwise until the right triangle aligns with the
unlock symbol on the Remote Transmitter housing (1A).
2. Install two (2), 3-volt (CR2032) batteries positive (+) side up (1B).
3. To replace the battery cover, align the right triangle with the
unlock symbol, press down and turn clockwise (1C) so that
the right triangle aligns with the lock symbol on the Remote
Transmitter housing.
To verify the batteries are inserted correctly
1. Press any button on the Remote Transmitter. The Digital Display
should activate showing the current Static Stimulation level.
2. If the Digital Display doesn’t activate, you may have inserted the
batteries backwards. Check to ensure that the (+) side is up.
3. If the Digital Display still does not activate, contact the Customer
Care Centre.
1A 1B 1C