www.petsafe.net 9
Treat Dispenser LED – Function and Response
Treat Dispenser Function LED Response
Treat Dispenser is turned on Battery status LEDs flash for 3 seconds
Treat Dispenser is on and idle No LEDs or flashing
Treat Dispenser is on with low battery 3 Red LEDs flash 3 times every 8 seconds
Signal from Handheld Remote is received 3 Orange LEDs flash once
Pairing Mode 3 Green LEDs flash once every second
Pairing successful 3 Orange LEDs flash once
Step 3
Prepare the Pee Pad and Pee Pad Clip
1. Pull up lever to open battery door and remove (4A).
2. Install one (1) 3-volt (CR2032) battery, positive (+) side up (4B), under the battery contact (4C).
3. Slide battery door back into place and snap down firmly to close (4D).
4A 4B 4C 4D
Risk of explosion if batteries are replaced by an incorrect type. Do not short circuit, mix
old and new batteries, dispose of in fire, or expose to water. When batteries are stored or
disposed, they must be protected from shorting. Dispose of used batteries properly.
To Next Page
Loading...
