Adjustment
13 - 10
13.05 Adjusting the thread trimmer –900/93
13.05.01 Adjusting the synchronizer
Requirement
1. When the machine has stopped it should be positioned in b.d.c. needle bar.
2. After thread trimming the machine should be positioned in t.d.c. take-up lever.
● Slightly loosen screw 1 and adjust it in accordance with requirement 1.
● Slightly loosen screw 2 and adjust it in accordance with requirement 2.
Only loosen screws 1 and 2, do not remove them completely!
Fig. 13 - 09
1
2
To Next Page
Loading...
